A nice bus that needs a little extra attention.	Rust in the driver's door.	Rust in the lower driver's door.	Rust in the nose on the passenger's side.
Rust in the passenger's door.	Rust in the rearward cargo door.	Outer skin of the cargo door cut away.	Rusty door latch guide.
First piece of the latch guide replica.	Completed latch guide piece.	Ready to cut the passenger's door.	Passenger's door skin removed.
Removed the rust scale and vacuumed out the mess.	Rust holes on the inner structure.	Inner structure cut out.	Fabricated a replacement piece.
Replacement held in place for welding.	Replacement held in place for welding.	New piece welded in.	New piece welded in.
Inner panels coated to prevent future damage.	Cut out bubbles.	Patch piece ready to go in. Both sides coated for protection.	Welded in.
Welded in.	Welded in.	Bad parts cut out.	Marking the necessary cuts.
Inner cargo structure finished.	Inner cargo structure finished.	First patch on driver side done.	Drivers side patch piece before welding.
Cut out the lower inner portion. Hidden rust.	Cleaned all of the rust off. It was later coated.	Cargo window latch has been previously patched poorly.	Very few of the welds in this area were good.
TIG welded the seam.	Drivers door finished up.	Inside of driver's door.	House carpet in the back.
Carpet and base board removed.	PERFECT cargo floors.	Cracked fuel lines were replaced.	Rear seat installed. 3/4 fold.
Rear seat installed. 3/4 fold.	Rear seat installed. 3/4 fold.

back to main